See update to first post

I left the car all day but it was probably just as well because the firmware update had to be done twice and they did give the car a bit of a clean up too.

I am not familiar with this feature but does the seam immediately behind the panel form the front of the sliding roof aperture? If it does it looks very possible that the repeated impact of the roof slamming tightly enough to seal the joint could be causing a stress fracture.

My 2022 PHEV has just had its first service including this recall updating ECU ( Engine Control Unit) and OBC ( On Board Charger) firmware. Possibly involving Engine Management System and OBC improvements but it would be nice to know more about these if only Hyundai was less secretive! Update: I hav...

My PHEV has just had its first service and the filler flap problem was addressed under recall 20DC04. I'll report if there are further problems.

I agree it is very heavy and nearly impossible to operate with one hand, painful for my old joints too. Only thing a can say is that there is no point snatching at it. The first couple of inches are slow but after that the gas struts start to reduce the load. There is a video of the conversion, a th...

The two forward facing devices are the camera in the centre of the windscreen and the radar "dish" just below the front number plate. Driving at speed in the heavy rain a few days ago I did notice that the cruise control played up a couple of times and I did get a warning message about saf...

This just happened to me at a very busy Tesco - highly embarrassing . After emptying the boot of detritus I tried the manual release and it didn't help. Eventually I used an old store card to work around the edge but as I was on my own i just got lucky eventually. Now I can see where the catch is i...

This just happened to me at a very busy Tesco - highly embarrassing . After emptying the boot of detritus I tried the manual release and it didn't help. Eventually I used an old store card to work around the edge but as I was on my own i just got lucky eventually. Now I can see where the catch is it...

The basic reason for not doing this is that the 12 volt system is not designed for the high current required by a conventional starter motor.